Demersal Trawl - Nephrops hopper trawl

A nephrops trawl towed on the seabed, with the mouth held open by a pair of otter boards (trawl doors) designed and rigged to be towed over rough seabeds to target nephrops

More Information

Alternate Names

prawn hopper

Gear Classification
Herding Gear, Mobile Gear, Towed or Dragged Gear, Trawls
Similar Gear
Demersal Trawl - General, Demersal Trawl - Nephrops trawl, Demersal Trawl - Rockhopper trawl, Twin Rig Trawl - Nephrops twin rig
Main Target Species (UK)
nephrops

Environmental Impact

Discards – Some Nephrops / prawn trawls can be susceptible to by-catch of small round fish and flat fish below the minimum conservation size due to the small mesh sizes that have to be used in these trawls to retain nephrops. Generally, compared to standard prawn trawls, prawn hopper trawls use slightly larger mesh in the trawls, the lower panel of the net stays clear of the seabed and the nets are opened up more, the meshes stay further open, and all this allows easy escape of seabed debris and small fish. They are generally towed in areas of low concentrations of other fish but still need to be fitted with legislation square mesh panels. Many of the skippers actually use square mesh panels with large mesh sizes than the regulation.

Seabed impact -As with all trawls there will be a certain degree of seabed impact with the trawl doors. When used properly the weight of any trawl door on the seabed will be much reduced compared to its weight on land. In most demersal trawl fisheries the weight of the trawl door on the seabed will be approximately 20-25% of its weight in air. This is due to several factors. One is about an 8 -10% reduction due to the weight of steel and other materials in water. The other major factor is the tension of the gear behind the trawl door and the uplift from the warp towing the trawl door. The ground gear on a nephrops hopper trawl is made up of large rubber discs spaced out using smaller rubber discs between them with it all threaded onto either wire or chain.  Although this can look heavy it is quite light contact on the seabed as it is designed to ‘bounce’ easily over the patches of hard rough ground interspersed on the muddy seabeds of some of the nephrops grounds.

Further Information

 

Nephrops, are also known as Langoustine or Dublin Bay Prawn, in UK, they are usually referred to as ‘prawns’  hence the name prawn net.

Nephrops usually inhabit areas of soft muddy sediments. Nephrops trawls have been developed to target nephrops on these clean soft seabeds. There are areas where nephrops live that are close to harder seabeds or where the muddy grounds are interspersed with stones and rocky out crops that would rip a standard nephrop trawl, it is these areas that a nephrops hopper trawl has been developed to fish over. The main difference is that the net is fitted with a rock hopper footrope to enable the gear to be able to tow over these ‘patchy’ areas. The design of the nets has altered too, the main difference is there is minimum of slack netting and the bottom panel of the gear is cut to stay clear of the seabed to prevent damage.  Often there are more of the larger nephrops in these areas that increases their value  to the fishermen.

 

show more information

Media

Quality nephrops ready for market

 

Iced whole nephrops ready for the market

 A haul of nephrops straight out of the trawl ready to be processed onboard.

A haul of nephrops straight out of the trawl ready to be processed onboard.

A nephrop, also known as a Dublin Bay prawn, Langoustine or prawn.

A 300mm square mesh panel as used in some nephrops fisheries to release bycatch.

A small coverless nephrops disc trawl on the quayside.